PCAN-Diag 2

PCAN-Diag 2 is a handheld diagnostics unit with a wide range of functions to allow investigation of a CAN bus, such as detection of the CAN bit rate, bus load measurement, and termination measurement. As well as receiving CAN messages, it can transmit either individual messages or entire sequences of them. In addition, the internal memory card allows tracing and playback of the CAN traffic

• High-speed CAN; on request: low-speed or single-wire CAN
• CAN specifications 2.0 A/B
• CAN bus connection via D-Sub, 9-pin
• Display with 320 x 240 pixel resolution
• Power supply via batteries (4 x 1.5 V AA) or using supply unit provided (low-voltage socket on unit)
• Internal memory card (2 GB) for saving projects. 
• Analysis of CAN networks at the physical and the protocol level
• Automatic bit rate detection based on a fixed value list
• Switchable listen-only mode
• Recording of incoming CAN messages to the internal memory card, if required, with CAN ID filtering
• Playback of trace files
• Transmitting individual CAN frames or CAN frame lists
• Measurement of CAN bus load, displayed by means of a time diagram, switchable display of error frames
• Measurement of the termination of the High-speed CAN bus, even while the system is running
• Switchable CAN termination for the connected bus, depending on the transceiver module used
• Voltage measurement for all pins of the CAN connector (D-Sub)
• Management of device configuration, transmit lists, symbol files, and all recorded data (screenshots, trace, and CSV files) in projects
• Scop function
• Operating temperature range from 0 to 50 °C